42
F FITTING THE FASCIA AND FINISHING INSTALLATION
To align the fascia, place the boom ange in rst and center the fascia using the boom ange and the two
holes in the chassis boom (circled boom) then swing the fascia up to meet the top locang notches (circled
top).
Slide the two prongs into the space between the chassis lid and black ramp in the two top corners using the
notches to center the fascia. You should feel some resistance as the prongs engage with the retainers.
The appliance’s remote contains the thermostat that will sense the room temperature and communicate this
back to the heater via radio frequency.
A wall mount cradle has been provided for the wireless control and where possible the control should be
housed in this cradle.
The locaon of this cradle should be decided by taking into account the following factors:
Simple and convenient access for the user
Away from direct sun light
A suitable distance away from the heater
Please ensure that the cradle is screwed rmly onto the wall using the screws provided.
To Next Page
Loading...
