Escea DF700 - First Time Appliance Operation

43
F3 

The remote arrives in a locked shipping state. To unlock it, please plug it into power via the USB-C port for 1
second.
Note: The remote does not come with a charging cable.
Charging the Remote
Charge the remote through the USB-C port in the boom of the remote using a USB-C cable. The remote can’t
be used while it is charging. The baery icon will “ll up” and turn green once it is fully charged.

To turn the re on, press the “POWER” ( ) buon once, and within a few seconds the appliance will begin its
startup sequence.
Note: Before starng up, the appliance has a 15 to 30-second pre-ignion purge. During this me, a fan runs
by itself before aempng to ignite. A visual indicator on the top of the remote screen shows which part of the
startup process the appliance is in (see above).
NOTE: once the front burner has lit there will be a xed 15 second delay before the rear burner will light.
Run the appliance on full for an hour with the windows and doors open in the dwelling. This will ensure any
running-in smells have the chance to dissipate.
The appliance is turned o by pressing the “POWER” buon once more. The remote will display the me only.
For further operaon instrucons please refer to the User Guide.