Escea DF700 - Product Description and Installation Process; Product Description; Recommended Install Process

8

A PRODUCT DESCRIPTION AND INSTALLATION PROCESS

The Escea DF-Series gas re is a room sealed gas appliance designed to be built into a masonry cavity or a false
chimney cavity. DF-series products are provided with standos to ensure adequate clearances to combusble
materials. These appliances are ued using co-linear exible aluminum ue (with PolyPro ue extensions for
some models) connected to a Power Flue. The user will control their re with the Radio Frequency (RF) remote
that will normally be located in its wall mount cradle. In addion to the RF remote the appliance has a single
auxiliary On/O buon on the unit. When not in operaon it is in a standby mode unless it is physically isolated
from the mains supply.
Recommended Install Process
The following diagram illustrates the steps required to install your gas re. The sequence in which you choose
to do these tasks will vary depending on your individual scenario. Please read these instrucons fully before
proceeding with the installaon.

Modifying the
cavity to suit
Install electrical /



cavity

fascia and test appliance
Secon B Secon C, D Secon E Secon F

Create The Framed Cavity Install electrical / gas

Install appliance and



and clad the cavity
Secon B Secon C, D Secon E Secon F