DX1500
Information Sheet for Builders and Architects
Gas Specications
Heat Output 10kW*
Gas Input / Consumption 40MJ/hr*
Gas Connection Lower right side of appliance, 1/2” BSP
Gas Type Natural Gas / LPG (NZ) / Propane (Aus)
Operating Pressure 0.84kPa NG / 2.2kPa LPG or Propane
Inlet Gas Pressure 1.2kPa to 5.0kPa NG
2.5kPa to 5.0kPa LPG or Propane
Power Requirement 3 pin earthed 230V power outlet to
be within 1.0m of right side of the
appliance
Product Dimensions
* Internal results pending conrmation from test laboratory
Appliance Information
For further information or specications, visit the technical
section of our website www.escea.com to view the latest
product Installation Manual.
Cavity Information
61
914
744
1828
382
70
372
1900
MIN
800
MIN
450
MIN
381
Front Side
Single Sided
Side
Double Sided
150 MIN
1150 MIN
400 MIN
Minimum Cavity Dimensions (mm):
The appliance must be installed prior
to and behind the nished wall surface.
Take into account any plaster board, tiles
or any other nishing surface that may
be intended for the nished wall surface.
Wall nishing materials must not en-
croach upon the minimum cavity
clearances shown.
The wall board that lines the outside
of the opening can be normal plaster
board and does not need to be non-
combustible.
800
MIN
Mantle Clearances (mm) ‘Hutch’ style cavity minimum dimensions (mm) Wall opening size for frameless / no fascia (mm)
630210_2
360
To Next Page
Need help?
General
