G8860 _2 Installation Manual AUS
2
Note:
THERE ARE A FEW THINGS TO CONSIDER BEFORE INSTALLATION
• Cavity Dimensions, Clearances, and fitting the Outer Skin Kit
• MUST be installed 100mm minimum off the floor
• Coupling of flue to fire
• Coupling of gas lines to fire
• Fixing the fire to cavity
• Electrical mains connection at rear left corner
• Gas pipe placement to the front right of the cavity.
The sequences you choose to do these tasks will vary on your individual scenario.
Please read these instructions fully before proceeding with your installation.
Leave the installation of the fascia panels until the very end of the installation and
commissioning to avoid damage to the fascia panels.
WARNING:
Failure to follow these instructions could cause a malfunction of the
heater, which, could result in death, serious bodily injury, and/or property
damage. Failure to follow these instructions may also void your fire
insurance and/or warranty.
Installation:
Installation must be carried out by a registered installer who, on completion of
the installation, must issue a certificate of compliance, in accordance with
national and/or local codes. If a certificate of compliance is not issued then the
Escea warranty may be void.
This appliance needs fresh air for safe operation and must be installed with
provisions for adequate combustion and ventilation air available to the room in
which it is to be operating.
Warranty Repair and Annual Servicing:
Warranty repair work must be carried out by a recognised Escea gas fire
technician. It is recommended that recognised Escea Gas fire technicians are
also used to carry out annual servicing requirements (particularly during the
warranty period). For contact details of authorised Escea technicians in your
area, please contact the retailer from whom the appliance was purchased.
The heater must be installed according to these instructions and in compliance
with all relevant building, gas fitting, electrical and other statutory regulations
(eg. AS 5601). Any shortcomings in the appliance and flue installation will be
the responsibility of the installer, and Escea will not be accountable for any
such failings or their consequences.
To Next Page
Loading...
