ESI RF - Unsupported RQ Commands

ESI RF BRIDGE User Guide DRAFT, rev 4
www.elec-solutions.com © 2013 Electronic Solutions, Inc. Page 11 of 13
Unsupported RQ Commands
These RQ commands are not supported when sent to an ESI RF Bridge from a PC or automation system.
RQ
Command
Data
Description
Send
Response
Notes
~
Randomize the ESI RF
Bridge’s RQ address
!BSB~;
!BSBU;
Not allowed.
~
Randomize the RQ
address of all RQ devices
!000~;
!BSBU;
Not allowed.
~
Randomize the RQ
address of one RQ device
!002~;
!BSBU;
Not allowed.
@
3 characters
(0-9 or A-Z)
Re-address all nodes
!000@AAA
!BSBU;
Illegal command.
d
scene
s
NS
Clear a scene
!002dCNS;
Currently not implemented.
Do not act on scene “C”.
d
- (minus sign)
Clear all scenes
!002d-;
Currently not implemented.
Do not act on any scene.
N
?
Request the ESI RF
Bridge’s default name
!BSBN?;
!BSBU;
Not allowed.
The name parameter is not
supported on the ESI RF Bridge
or on RF nodes networked to
the ESI RF Bridge.
N
1-16
characters
Assign a name to the ESI
RF Bridge
!BSBNrf_bridge;
!BSBU;
Not allowed.
Cannot assign a name to the
ESI RF Bridge.
Valid RF Commands
NOTE: RF commands will be fully supported in the Production release.