ESI RF User Manual

September 2013, DRAFT rev 4 © 2013 Electronic Solutions, Inc. Page 1 of 13
ESI RF BRIDGE
User Guide — DRAFT, rev 4
Electronic Solutions, Inc.
1355 Horizon Avenue
Lafayette, CO 80026 U.S.A.
www.elec-solutions.com
Tel: (303) 469-9322
Introduction
The ESI RF Bridge translates between ESI RF communication and serial ASCII strings via an RS-232 connection.
The messages can be similar to RQ Bridge, which allows ESI RF products to be controlled by Home Automation
Systems, Building Management Systems, or other RS-232 sources with existing ESI RQ drivers. The ESI RF
Bridge communicates to ESI RF devices (motors and the RF Switch Interface) and RQ devices (motors and motor
controls) using the ESI RF RQ Transceiver interface.
Parts and Accessories
Included:
 ESI RF Bridge.
 ESI RF Antenna 2.4 GHz (onboard).
 External power supply 5 volt DC, 1A
(with interchangeable domestic /
international AC plugin adapters).
 USB to Mini-B cable, 3 feet
(for external power supply).
Usage:
 Indoor Use in Dry Locations Only.
Not Included:
 SUITE remote.
 PC computer.
 RS-232 serial cable.
USB Port:
 The USB port is only for power, not
data.
 Use only the 5 volt DC external power
supply provided.
FRONT
BACK
LED

ESI RF Specifications

General

Brand	ESI
Model	RF
Category	Control Unit
Language	English

Summary

Introduction

Product Components and Usage

Parts and Accessories

Lists included and not included parts, and usage details for the ESI RF Bridge.

USB Port Functionality

Explains the USB port is for power only, not data, and requires the provided supply.

System Setup and Configuration

ESI RF Bridge Factory Defaults

Details the default settings for the ESI RF Bridge, including baud rate and echo.

Hardware Requirements

Lists necessary hardware like the ESI RF Bridge, PC, terminal program, and cables.

Terminal Emulator Settings

Details serial port settings, flow control, local echo, and line termination.

RS-232 Cable and Pinout

Explains the RS-232 cable connection and pinout for connecting to the ESI RF Bridge.

Bridge Configuration Steps

Covers applying power and configuring the bridge via terminal emulator menus.

Network Creation and Management

Create an ESI RF Network

Describes how to build an ESI RF network with devices and transceivers.

Network Join and Management

Explains network invite, search, and device joining procedures using buttons and LEDs.

Communication Protocols and Commands

RQ Message Format Overview

Details the structure, addressing, and character usage of RQ messages.

Valid RQ Commands

Lists and explains supported RQ commands for device control and status.

Unsupported RQ Commands

Lists RQ commands that are not supported when sent to the ESI RF Bridge.

Specifications and Safety

Product Specifications

Provides technical details like usage, power, frequency, dimensions, and listed accessories.

Safety Instructions

Outlines important safety precautions for installation and operation of the device.