1. Use your key to unclock the batte pin, then pull the batte
up from the bottom and slide it downward to remove it from
the frame.
2. Connect the charger to the po located on the batte rst,
then plug the charger into the AC power outlet to charge it.
3. Plug your charge into an outlet. The indicator light will turn
green.
Green Light:
Not charging/Fully charged
Red Light:
Charging/Not fully charged
Tip: To replace the batte, inse the top end in rst, slide it upward, then
push in the bottom end until it’s fully seated.
Tip: Allow the batte to fully charge for about 8-12 hours for the rst few
cycles. After this, you may charge it normally (4-6 hours).
08
To Next Page
Loading...