Guidance and manufacturer's declaration -
electromagnetic emissions
Warning: Use of this equipment adjacent to or stacked with other
equipment should be avoided because it could result in improper
operation. If such use is necessary, this equipment and the other
equipment should be observed to verify that they are operating normally.
Warning: Use of accessories, transducers and cables other than those
specied or provided by the manufacturer of this equipment could result in
increased electromagnetic emissions or decreased electromagnetic
immunity of this equipment and result in improper operation.
Warning: Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should be used no closer
than 30 cm (12 inches) to any part of the synapsis wave 2, including cables
specied by the manufacturer. Otherwise, degradation of the performance
of this equipment could result.
The synapsis wave 2 is intended for use in the electromagnetic
environment specied below. The customer or the user of the synapsis
wave 2 should assure that it is used in such an environment.
Not mentioned test sections are not applicable for synapsis wave 2.
Emissions test Compliance
Electromagnetic environment -
guidance
RF emissions
CISPR 11
Group 1
The synapsis wave 2 uses RF
energy only for ist internal
function. Therefore, RF
emissions are very low and are
not likely to cause any
interference in nearby
electronic equipment.
The synapsis wave 2 is suitable
in all establishments,
including domestic
establishments and those
directly connected to the
public low-voltage power
supply network that supplies
buildings used for domestic
purposes.
RF emissions
CISPR 11
Class B
To Next Page
Loading...