12
Names and functions of parts (remote control)
a
b
f
c
d
e
g
If both the main unit and the remote control
have buttons with the same function, we only
explain procedures using one of them in this
manual. However, the other can also be used in
the same manner.
0 The buttons not explained here do not function with this unit.
0 This remote control can also be used for other Esoteric Super
Audio CD/CD players and D/A converters.
a
ON/LIGHT button
Use to confirm selection of some of the settings explained in
“Additional settings” (page 17). You can also assign a name to a
connector using this button (pages 17-20).
0 You cannot turn the unit on or off using this button.
b
INPUT buttons (l/;)
Press these buttons to switch between input sources. Select the
connector that is connected to the device you want to play.
Use to select settings for “Balance and input level settings” (page
15) and “Additional settings” (page 17).
Use as cursor keys when entering an input source name.
c
DIMMER button
Use to adjust the brightness of the display and indicators
(page 14).
d
SETUP button
Use with “Balance and input level settings” and “Additional set-
tings” (pages 15 and 17).
e
CLEAR button
Press to cancel a selection when choosing a setting (pages 15
and 17).
f
VOLUME buttons (+/−)
Use to adjust the volume. Press the + button to increase the vol-
ume and the − button to decrease it.
0 If you set the RCA 2 input jacks to “THRU”, the VOLUME buttons
will not work when the input is set to RCA2 (page 19).
g
MUTING button
Press this button to temporarily mute the sound. Press again to
restore the volume setting (page 14).
0 When muted, “MUTE” and the ordinary display are shown
alternately.
To Next Page
Loading...
Need help?
General
