21
Troubleshooting
If you experience a problem with this unit, please take a moment to
review the following information before requesting service. Moreover,
be aware that the problem might be caused by something other
than this unit. Confirm that connected devices are also being used
correctly.
If this unit still does not operate correctly, contact the retailer where
you purchased the unit or TEAC customer support (see the back cover
for contact information).
The unit does not turn on.
e
Check that the power cord is plugged into a working power outlet.
e Check that the power cord is properly connected to this unit.
Remote control does not work.
e Turn the main unit on (page 13).
e
If the batteries are exhausted, replace both of them with new ones
(page 11).
e
The remote control will not work if there are obstructions between
it and the main unit. Point the remote control toward the main unit
and use it within 7 m (23 ft) of the front panel (page 11).
A television or other device is operating improperly.
e
This unit’s remote control might cause some televisions with remote
control functions to operate improperly.
Cannot select input.
e Make sure the input source is not set to be skipped (page 20).
VOLUME knob does not work.
e When you set the RCA 2 input jacks to “THRU”, the VOLUME knob
will not work if the RCA 2 input is the active input (page 19).
Volume display blinks.
e The volume value exceeds the maximum total gain of this unit.
Lower the volume until the display stops blinking.
Since this unit uses a microcontroller, external noise and other
interference can cause the unit to malfunction. If this occurs,
turn the unit off once, and then restart it after waiting for about
one minute.
To Next Page
Loading...
Need help?
General
