29
English
Adjusting the volume Muting the output
You can adjust the volume of the analog audio outputs with this unit.
This is convenient when connecting the unit directly to a power
amplifier without a pre-amplifier.
o This can only be used when the attenuator setting is ON (see p. 26).
Press the remote control VOLUME + button to increase the volume,
and the − button to decrease it. The volume can be adjusted in
1 dB steps (−99 dB to 0 dB).
Mute level during Super Audio CD playback and DSD signal
format conversion (see p. 25)
When the analog output setting is XLR2 or XLR3 and the XLR out-
put gain setting is +6dB (see p. 27), the volume is muted (−∞) at
−54 dB. At all other output settings, the volume is muted (−∞) at
−48 dB.
Press the remote control MUTE button to temporarily mute the
sound. Press again to restore the previous volume setting.
o This can only be used when the attenuator setting is ON (see p. 26).
V CAUTION
The volume setting is retained even when the power is turned
off. Always minimize the volume of this unit before turning on
a connected power amplifier.
Never connect this unit directly to a power amplifier when the
attenuator is set to OFF. Doing so could cause the output of
sudden loud sounds resulting in harm to hearing and speaker
damage.
To Next Page
Loading...
Need help?
General
