Contents
1.0 Preface
2.0 General Notes
2.1 Safety Precaution Notes
2.2 Installation Notes
2.3 Operating Notes
2.4 Notes on Moving and Repairing the Unit
2.5 Operation Notes
2.6 General Requirements
3.0 Component Checklist
4.0 Positioning the Unit
4.1 Some notes on Ducting
4.2 Water Supply
4.3 Outlet/Terminal fittings (Taps etc.)
4.4 Limitations
4.5 Hot Water ASHP Package
4.6 Basic system schematic
5.0 Specification
5.1 Appearance
5.2 Dimensions
5.3 Performance
5.3.1 Performance assumptions
5.4 DHW Recovery Times
6.0 Installation
6.1 Installation Diagram
6.2 Indirect Thermal cut-out (dual stat) and 2-Port Motorised Valve
6.3 Pipe fittings
6.4 Cold Water Supply
6.5 Cold Water Combination Valve
6.6 Drain-Off Cock
6.7 Outlet Pipe Work
6.8 Secondary Circulation of DHW
6.9 TPRV
6.10 Warnings
6.11 Discharge Pipe Work
6.12 Expansion Vessel
6.13 G3 Requirement
6.14 G3 Guidance Section
7.0 How to connect to the Heat Pump
7.1 Vacuum and filling refrigerants
7.2 Controller System Test
7.3 Preparing for refrigerants
7.4 Insulation Treatment
7.5 Wiring
7.6 Earthing
7.7 Unit System Controls
7.8 Immersion Heater
To Next Page
Loading...
