1.0 Preface:
This manual includes the necessary information about installation and maintenance of the Ecocent. Please read
this manual carefully before you install or carry out maintenance on the unit.
When installing the unit, please carry out the work strictly in accordance with the manual, relevant Regulations
and good practice.
Please do not switch the unit on until you are sure that it has been properly installed, electrically, mechanically,
hydraulically and that there is water in the system.
The installer should explain to the end user how to operate and maintain the unit before handing over the unit to
the end user. Also, the installer should advise the end user to read the manual fully before operating the unit and
leave this manual with end user.
Further, improper installation, operation and/or maintenance, and failure to maintain the unit as per this manual
will invalidate any unit warranty or guarantee.
The manual may be altered and/or updated in any way at the sole discretion of the supplier and/or ESP without
notice.
2.0 General Notes:
2.1 Safety Precaution notes
Below you will find information that is critical for the safe and proper installation and the use of the unit. Please
make sure that you understand the contents to help avoid the risk of injury or damage to the unit/other property.
2.2 Installation Notes:
Professional
& qualified
installer
is required
The heat pump must only be installed by a suitably qualified
engineer. Failure to ensure this can cause damage to the
unit and may cause serious injury. The warranty on the unit
will also be invalidated if a suitably qualified engineer is not
engaged to install it.
Please make sure that the unit and power supply are
soundly earthed.
If you are installing the unit in a small room, please give full
consideration to adequate ventilation being available in the
event of a refrigerant leak.
Do not install the unit near to a gas installation. This unit is
designed to be installed inside a building.
Ensure that this unit is installed on a solid level floor. Make
sure that you have a suitable facility to cater for disposal of
condensate from the condensate drain on the unit.
Make sure that this unit is connected to the power supply via
a fused switched spur and suitably sized MCB for the
domestic ring main.
The unit must be installed level across the whole diameter.
Failure to install the unit level will mean that condensate can
spill over the lip of the cylinder.
To Next Page
Loading...
