Espa Evopool SilenPlus ControlSystem - Operation; Remote Mode; Manual Mode; No Water Fault and Retries

• Configuring Backwash Plus.
The maximum and minimum speeds are set, a
ways maintaining
a differential of 20 Hz between
them
·
Minimum = 1,600/2,320 RPM (20/40 Hz), [= fs]
·
Maximum = 1,740/2,900 RPM (30/50 Hz)
•
Configuring the Mixed Cycle (Manual only)
The factory setting is 2,320 RPM (40 Hz)
· Minimum = 1,600 RPM (20 Hz)
· Maximum = 2,900 RPM (5
0 Hz), [= fs]
If M and F are not pressed for 5 seconds the new va
ues are stored and the configuration mode is
deactivated.
SilenPlus
can also be entirely configured using
the EspaEvopool application.
7. BUILT-IN TIMER
The SilenPlus pump has an interna
l clock that can
operate as a start and stop timer, making external
programming unnecessary.
With this function, SilenPlus
can operate entirely ind
pendently.
WARNING: the programming and maintenance
of the timer is only possible using an Android
device
with Bluetooth connectivity and the
EspaEvopool
app, available from
7.1 Activating the timer.
DANGER.Electrocution risk.
Never open the SilenPlus
cover without turning
the power supply off at least 5 minutes
hand.
• Lift the SilenPlus
cover by loosening the 4 screws.
(See figure 5)
• Activate the Timer using the mini-
switch, moving it
to the “ON” position.
•
Replace the cover and fix it with the 4 screws.
Torque: 0.5 Nm.
7.2. Time setting.
Link SilenPlus wi
th the external device using Bluetooth,
following the instructions on the device.
Run the EspaEvopool
app and follow its indications.
11
The maximum and minimum speeds are set, a
l-
a differential of 20 Hz between
Minimum = 1,600/2,320 RPM (20/40 Hz), [= fs]
Maximum = 1,740/2,900 RPM (30/50 Hz)
Configuring the Mixed Cycle (Manual only)
The factory setting is 2,320 RPM (40 Hz)
0 Hz), [= fs]
If M and F are not pressed for 5 seconds the new va
l-
ues are stored and the configuration mode is
can also be entirely configured using
l clock that can
operate as a start and stop timer, making external
can operate entirely ind
e-
WARNING: the programming and maintenance
of the timer is only possible using an Android
with Bluetooth connectivity and the
app, available from
www.espa.com
cover without turning
the power supply off at least 5 minutes
before
cover by loosening the 4 screws.
switch, moving it
Replace the cover and fix it with the 4 screws.
th the external device using Bluetooth,
following the instructions on the device.
app and follow its indications.
8. MAINTENANCE
ControlSystem:
If ControlSystem
is not communicating with
may be necessary to replace the batt
Proceed as in section 4.2.
It is a 1.5 V, CR2450 type battery.
SilenPlus:
Our SilenPlus
equipment is maintenance free.
Clean the equipment with a damp cloth and without
using aggressive products.
In freezing weather, take the precaution of em
tying the pipes.
If the equipment is going to be inactive for a
long time, you are recommended to dismantle it
and keep it in a dry, well
WARNING: in case of a breakdown, the equi
ment must only be touched by an authorised
service technician.
The list of official technical services can be found at
www.espa.com.
When the time comes to throw the product away, it
does not contain any toxic or polluting material. The
main components are duly identified so you can di
pose of them selectively.
9. DE
CLARATION OF COMPLIANCE
We declare, under our own responsibility, that the
products in this manual meet the following Community
directives and technical regulations:
-
Directive 2004/108/EC (EMC)
· Regulations EN 61000-
6
- Directive 2006/95/EC
(Low Voltage)
· Regulation EN 60730-
1 and EN 60730
Pere Tubert (Technical Manager)
ESPA 2025, SL
Ctra.deMieres, s/n
Girona
-
EN
is not communicating with
SilenPlus it
may be necessary to replace the batt
ery.
It is a 1.5 V, CR2450 type battery.
equipment is maintenance free.
Clean the equipment with a damp cloth and without
In freezing weather, take the precaution of em
p-
If the equipment is going to be inactive for a
long time, you are recommended to dismantle it
and keep it in a dry, well
-ventilated place.
WARNING: in case of a breakdown, the equi
p-
ment must only be touched by an authorised
The list of official technical services can be found at
When the time comes to throw the product away, it
does not contain any toxic or polluting material. The
main components are duly identified so you can di
s-
CLARATION OF COMPLIANCE
We declare, under our own responsibility, that the
products in this manual meet the following Community
directives and technical regulations:
Directive 2004/108/EC (EMC)
6
-1 and EN 61000-6-3
(Low Voltage)
1 and EN 60730
-2-6
Pere Tubert (Technical Manager)
ESPA 2025, SL
Ctra.deMieres, s/n
– 17820 Banyoles
-
Spain