NOTE: To assemble the securing bar on the frame of the baby cot (in the upper position),
repeat steps described in items 10, 11 and 12 in the reverse order.
13. Adjust the height of the bedside crib to the mattress. Maximum difference in between
the levels of the bottom edge of the window (exit) of the bedside crib and the upper edge
of the mattress of the adult bed should be 2 cm.
14. Fix the fixing tape to the baby cot using the buckle (I). Pull the second end of the fixing
tape through the frame of the adult bed (2) and slide it in the second buckle of the fixing
tape (3) creating a loop around the frame of the adult bed. Repeat on the other side.
Move the bedside crib to the matters of the adult bed as close as possible (they should
adhere to one another) and eliminate any loose parts on the fixing tapes by pulling
the protruding tapes of both fixing tapes (the loops around the frame of the adult bed
should not be loose).
NOTE! Before putting the child inside the bedside crib make sure that the crib is properly
fixed to the adult bed, that fixing tapes are properly tightened and make it impossible
for the bedside crib to move away from the adult bed, as well as that the crib adheres
to the mattress and that the window (exit) is at an appropriate height.
15. Insert the protruding parts of the fixing tapes in the pockets located under
the bedside crib.
16. To shorten the telescope leg, press the button (1) and slide it inside.
NOTE! The telescope leg slides out automatically to its longest position.
17. PLAYPEN
Position the baby cot at the lowest position: “1”.
18. Remove the mattress. Pull the end part of the zipper of the bottom with the brackets
out of the securing mechanism (1), unzip the zipper securing the bottom to the baby cot (2)
and then slide it out of the baby cot.
19. Open the buckles securing the baby cot bottom in the upper position, unzip both
zippers and push the bottom of the playpen down.
20. Insert plastic handles of the playpen located above its bottom on the legs connecting
elements.
NOTE! Make sure the bottom is properly secured to the legs connecting elements
by trying to slightly lift it.
21. P ut the mattress on the bottom.
NOTE! To return to the baby cot function, repeat steps described in items 10, 11, 12 13, 14,
15 in the reverse order.
22. WHEELS WITH BRAKES
The product is equipped with wheels to freely move it. Each wheel is equipped with
a parking brake. To release the brake - lift the lever at the wheel. To engage the brake -
press the lever so it is in the bottom position.
NOTE! Do not change the position of the product if the child is inside of it - wheels
can be released only to change the product position - at any other case, engage the brake
on each wheel.
pl | EN | de | ru | cz | sk | hu | bg | ua
To Next Page
Loading...