Espressif ESP32-C3-DevKitM-1 User Manual

Key Component Description
I/O Connector
All available GPIO pins (except for the SPI bus for flash) are broken
out to the pin headers on the board. For details, please see Header
Block.
Boot Button
Download button. Holding down Boot and then
pressing Reset initiates Firmware Download mode for downloading
firmware through the serial port.
Micro-USB Port
USB interface. Power supply for the board as well as the
communication interface between a computer and the ESP32-C3FN4
chip.
Reset Button Press this button to restart the system.
USB to UART
Bridge
Single USB-UART bridge chip provides transfer rates up to 3 Mbps.
RGB LED Addressable RGB LED (WS2812), driven by GPIO8.
Start Application Development
Before powering up your ESP32-C3-DevKitM-1, please make sure that it is in good
condition with no obvious signs of damage.
Required Hardware
 ESP32-C3-DevKitM-1
 USB 2.0 cable (Standard-A to Micro-B)
 Computer running Windows, Linux, or macOS
Software Setup
Please proceed to Get Started, where Section Installation Step by Step will quickly help
you set up the development environment and then flash an application example onto
your ESP32-C3-DevKitM-1.

Espressif ESP32-C3-DevKitM-1 Specifications

General

Brand	Espressif
Model	ESP32-C3-DevKitM-1
Category	Motherboard
Language	English