5
SPEED INDICTOR BAR: The speed indicator bar displays which speed (1-5) the mixer is currently set to.
If the mixer senses that there is an uneven load in the mixer bowl, a notification will flash on the display.
DIGITAL DISPLAY: The digital displays are divided into two sections. The left single-digit display is the
program display area, which is used to display the current set program number. The right two-digit
display is the time display, which is used to show the time in minutes, or in seconds if the timer is less
than 1 minute. If the time is shown in minutes, a dot on the timer display will flash to signify that it is still
counting. If a program is not selected and the timer is not set, it will count up from 0 and the program
display will show 0. If the timer is above 99, the program display will show "-", indicating a countdown
If a program is selected the program display area will display the current program number (1-6) and the
time display area will display the remaining time that corresponds to the specific program. The timer will
always count down based on the program that is selected
BUTTONS: The buttons on the control panel are as follows:
Start/Pause – Begins or pauses the mixer’s motor
Stop – Stops the mixer’s motor
Timer Up Arrow – Increases the amount of time on
the timer
Timer Down Arrow – Decreases the amount of time
on the timer
Speed Up Arrow – Increases the speed of the motor
Speed Down Arrow – Decreases the speed of the
motor
Programs – Used to create or select from preset programs
Program Selection Numbers (1-6) – Chooses the program that corresponds to the respective program
number
CONTROLS
NOTE: New mixer bowls and agitators (beaters, whip, and doughhook) should be thoroughly washed
with hot water and a mild soap solution, rinsed with either a mild soda or vinegar solution, and
thoroughly rinsed with clean water BEFORE being used. This cleaning procedure should also be
followed for bowls and agitators before whipping egg whites or whole eggs.
CONTROL PANEL