6
POWER ON AND POWER OFF
After powered on, all of the indicators and the digital display will flash on, and the buzzer will sound for
1 second. If the device was normally shut down before powered off last time, it will enter a standby state
after 1 second. The digital displays will all display 0, and the indicator will display speed level 1. If the
motor was running when last powered off, the state before the unit was powered off will be restored
after 1 second, but the motor will change from a running state to a paused state. In case of a shutdown,
please stop the motor first and then unplug the power.
START AND STOP THE MIXER
Before starting the mixer, make sure the bowl is attached and the lift is engaged in the “up” position,
then press the start/stop button to start the motor. Whether the motor is started or not, you can adjust
the speed by pressing the up and down speed button arrows. You can also adjust the timer by pressing
the up or down timer arrows on the display.
If the timer is adjusted after the mixer is started, the adjustment time will not be remembered and
will only be effective for this operation. If the timer is not set to 0, the countdown will start again
immediately.
After the mixer is started, press the Start/Pause button in order to temporarily pause the running of
the motor. When the motor is paused, the timer will also stop until the Start button is pressed again, at
which time it will start again.
To return to the standby state, press the Stop button when the mixer is running or suspended.
HOW TO RECORD AND SET THE PROGRAM
1. Press the Start/Pause button to start the machine. Once this is pressed, the machine will begin
recording your actions.
2. Use the up and down arrows to select your speed preference.
3. If you’d like your speed to change mid-mix, adjust speed at your desired time (for example: changing
from speed 1 to speed 2 at 30 seconds, just press the up arrow to the second speed indicator at the
30 second mark). There is no need to pause or stop the mixer to change speed.
4. If you want the mixer to pause to add ingredients, press the Start/Pause button, and lower the bowl
lever (Error E2 will show in the display, disregard as that error just means the bowl is down). This will
tell the program to pause itself at the desired time. (For example – if you want the mixer to pause at
60 seconds, press the Start/Pause button, lower the bowl, add ingredients, raise the bowl and press
the Start/Pause Button to begin again. This will be a saved function in your program.)
OPERATION
To Next Page
Loading...
Need help?
General
