Need help?Do you have a question about the Esu LokPilot V3.0 and is the answer not in the manual?
General| Brand | Esu |
|---|---|
| Model | LokPilot V3.0 |
| Category | Media Converter |
| Language | English |
Comparison table detailing features and specifications of various LokPilot V3.0 models.
Details compatibility with various DC and coreless motors.
Explains programming modes like POM and compatibility with digital systems.
Instructions on physical mounting, avoiding short circuits, and heat management.
Step-by-step guide for installing decoders with NEM 652 connectors.
Guide for installing decoders with the 6-pole NEM 651 connector.
Instructions for installing decoders with the 21MTC interface.
General guidelines for connecting motors and track, emphasizing care.
Describes operation with different digital systems like DCC, Motorola, Selectrix.
Introduction to adjusting decoder parameters and CVs.
Overview of software-governed properties that can be adjusted.
Explains the concept of Configuration Variables (CVs) for decoder settings.
Guides on programming LokPilot decoders with various digital systems.
Instructions for programming using DCC systems, including POM.
How to program decoders using the ESU ECOS command station.
Guide for programming with the Märklin® 6021 central unit.
Instructions for programming using the Märklin® Mobile Station®.
Guide for programming with the Märklin® Central Station.
Easiest method for setting CVs using the ESU LokProgrammer.
How to set short (1-127) addresses for DCC operation.
How to set long (4-digit) addresses in DCC mode using CVs.
Setting independent acceleration and deceleration times.
Setting minimum, medium, and maximum speeds for locomotive control.
Defining custom speed curves using CVs or the speed table.
How locomotives transition between digital and analog sectors.
Configuring brake sectors for stopping trains at signals or specific points.
Setting a constant brake distance independent of speed using CV 254.
Fine-tuning load compensation for smooth motor control.
Recommended BACK-EMF settings for various common motors.
Adjusting load compensation (CVs 53-55) for optimal motor performance.
Adjusting CV 54 ("K") to influence load control response strength.
Adjusting CV 55 ("I") for motor inertia and smooth operation.
Setting CV 53 for motor EMF voltage at maximum revs.
Using CV 56 to adjust load control influence for prototypical gradients.
How to assign functions to specific F-buttons for control.
Explains various lighting and special effects for function outputs.
Details enabling outputs and selecting from 12 different lighting effects.
How to adjust the brightness of individual lamps in 15 steps.
Comprehensive list of CVs for DCC LokPilot decoders.
List of CVs specifically supported by M4-Decoder models.
To Next Page
