eta TEMA - EQUIPMENT and ACCESSORIES (Fig. 1); Preparing the Cleaner for Use

II. EQUIPMENT AND ACCESSORIES (fig. 1)
A – vacuum cleaner
A1 – suction vent A10 – power cord
A2 – lid A11 – parking holes
A3 – lid lock A12 – exhaust grid
A4 – START/STOP button A13 – foam micro-filter
A5 – power cord winding button A14 – filter (adapter) holder
A6 – electric motor regulation A15 – dust filter
A7 – full filter signaling A16 – suction micro-filter
A8 – cover (grid) A17 – accessories compartment lid
A9 – handle
B – accessories
B1 – floor nozzle B4 – upholstery nozzle
B2 – suction hose B5 – brush
B3 – suction tube B6 – crevice nozzle
Note
Accessory options TURBO nozzle, adapter for a hard floor, narrow floor, dust cloth bag
etc. are available for cleaner vacuum.
i
III. PREPARING THE CLEANER FOR USE
Hose
– Connect hose B2 to the vacuum cleaner by inserting the end piece to suction vent A1 to
the maximum position (Fig. 2). You will hear a clicking sound.
– Disconnect the hose by pressing the button on the end piece and remove the hose by
pulling it slightly.
Telescopic tube
– You can connect tube B3 with hose handle B2 by slight pushing the handle to the tube
(Fig. 3).
– You can disconnect the tube by pulling the handle slightly out of the tube.
– The telescopic tube allows setting suitable length to fit your figure. Press the lock pin in
the direction of the arrow and pull out or push in the required length of the tube (Fig. 4).
When you release the lock projection, the tube length is fixed. When pulling out, keep the
tube in safe distance from your face as the tube is very long.
Floor nozzle
– Connect and disconnect the accessories (B1) in the same way as the tube (Fig. 3).
Floor / crevice nozzle / brush
– Connect and disconnect the accessories (B4, B5, B6) in the same way as the tube (Fig. 3).
You can connect the appliance directly to the hose handle or to the telescopic tube.
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord A10 and plug the power cord into a socket. Assemble the
vacuum cleaner accessories B1, B2, B3 (Fig. 2, 3).
22
GB
/ 40