Why is the suction output not sufficient on my eta Vacuum Cleaner?
If your eta Vacuum Cleaner's suction output is insufficient, try the following: * Ensure the suction regulation is set to MAX. * Close any open suction holes on the hose handle. * Replace the dust filter if it's full. * Clean or replace the micro-filters if they are clogged. * Check for and remove any blockages in the nozzle, suction hose, tube, or accessories.
How to fix eta Aero if motor won't start?
If the motor of your eta Vacuum Cleaner won't start, check if the power cord is properly connected to the plug and socket. Also, ensure that the power button is switched on. Push the button to activate it.
What to do if the cable cannot be wound in the entire length in my eta Aero?
If the cable of your eta Vacuum Cleaner cannot be wound in the entire length, it might be twisted. Straighten the cable, pull out about 50 cm, and then push the button again.
Why the lid cannot be closed on my eta Aero?
If the lid of your eta Vacuum Cleaner cannot be closed and the safety lock is activated, it may be due to the dust filter being incorrectly inserted in the holder. Check and repair the fastening of the cardboard front in the holder.
General| Category | Vacuum Cleaner |
|---|---|
| Power source | Battery |
| Filter Type | HEPA |
| Model | Aero |
| Dust Capacity | 0.45 L |
| Cord Length | Cordless |
To Next Page
