eta Aero User Manual

Replacing micro-filters
After replacing about 5 dust filters, micro-filters must be cleaned or replaced with new ones.
Dispose of the used dust filter and the micro-filters with common municipal waste.
You can buy replacement filters and micro-filters in electro store chain.
Suction micro-filter
Take out filter A16 by pulling it upwards (Fig. 13). Clean the filter in running lukewarm water,
e.g. using a cloth or a soft brush and let it dry completely. After drying, put the grid with
a new micro-filter in the opposite direction behind the guide ribs and slide it to the suction
area of the vacuum cleaner to the maximum position.
Exhaust micro-filter
Remove the outlet grille A12 by pressing the arrest button and folding it back (Fig. 14).
Tap the dust out of the lter over a dustbin or to clean the lter through a blowing
(we recommend the lter cleaning outside of living area for hygiene reasons). If the protection
micro lter is very dirty, you can also rinse the pleated side of the HEPA lter under lukewarm
slow-running tap. Hold the lter in such a way that the pleated side points upwards and
the water ows parallel to the pleats. Hold the lter at an angle so that the water washes
away the dirt inside the pleats. Turn the lter 180° and let the water ow along the pleats
in the opposite direction. Continue this process until the lter is clean. Having done the
maintenance, the HEPA lter A13 can be inserted back into the vacuum cleaner. Insert the
projections on the back cover into two holes in the vacuum cleaner cover and snap the cover.
ATTENTION
– Do not use any aggressive washing or cleaning agents or hot water to clean
the HEPA filter and the micro-filter.
– Washing the HEPA filter decreases its filtration capabilities. The maximum number
of washing the filter is 3x. Then it is necessary to buy a new one.
– The HEPA filter and the micro-filters are not intended for cleaning in a dishwasher.
– Neglecting regular replacement of micro-filters can result in the vacuum cleaner failure!
– Make sure that the contact surfaces and sealing elements are functional.
– We recommend replacing the HEPA filter twice a year. Replace the other micro-filters
if they cannot be cleaned properly or if they are damaged. You can buy a replacement
dust filter, a HEPA filter and a micro-filter in the elektro shop chain.
!
Storing accessories
Accessory, floor nozzle, suction tubes and hose may be disassembled or left assembled and
hung on the back side or on the bottom of the vacuum cleaner (pic. 15). For better stability,
slide individual parts of the tube to each other so that the tube is as short as possible.
When storing, always set the floor nozzle to the carpet position (i.e. with the brush
retracted); thus you will prevent bending of the bristles.
V. MAINTENANCE
Store the vacuum cleaner at a dry place, far enough from heat sources (e.g. fireplace, stove,
heating element) and protect it from weather conditions (e.g. rain, sunshine).
Treat surface of the appliance with a soft and damp cloth, do not use coarse and aggressive
detergents! Store the appliance properly cleaned at a dry, dust-free place out of reach
of children and incapacitated people.
24
GB
/ 48

eta Aero Specifications

General

Brand	eta
Model	Aero
Category	Vacuum Cleaner
Language	English