Floor / crevice nozzle / brush
– Connect and disconnect the accessories (B4, B5, B6) in the same way as the tube (Fig. 3).
You can connect the appliance directly to the hose handle or to the telescopic tube.
IV. USE OF VACUUM CLEANER
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord A10 and plug the power cord into a socket. Assemble the
vacuum cleaner accessories B (Fig. 2, 3, 4). If the cleaner is fitted with telescopic tube B3,
adjust its length to fit your figure (Fig. 3). Floor nozzle B1 is designed to be used to clean
carpets or smooth flooring (Fig. 5). If the floor nozzle is fitted with a brush, pull it out by
switching over a flap when vacuuming hard floorings. The parquet nozzle B7 is designed
mainly for vacuuming smooth floors (wood tiles, linoleum, floating floor etc.). You can use
crevice nozzle B4 for vacuuming places that are hard to access (Fig. 6). Upholstery nozzle
B5 or brush B6 can be used to clean various types of furniture (Fig. 7, 8). The vacuum
cleaner can be switched on or off by pushing button A4 marked with the symbol
(Fig. 9).
You can set the suction power by setting the regulator A6. The minimum suction power is
recommended for fine fabrics (e.g. curtains, drapes). The maximum suction power
is recommended for floor coverings (e.g. heavy-duty carpets). After finishing work, switch
off the vacuum cleaner and unplug it from the power supply. By switching button A5 with
symbol
(Fig. 9) the power cord will be wound automatically. The vacuum cleaner can
be held and carried by handle A9.
Full dust filter signaling
If the coloured field is displayed permanently on the indicator A7 while the floor nozzle
is lifted above the cleaned surface at the maximum suction power, the dust filter A15
must be replaced. Disregard changes on the indicator during vacuuming.
Dust filter replacement
Lift off vacuum cleaner lid A3 by pushing lock A2 to the locked position (Fig. 11). Pull out
the dust filter lock A15 from the guide ribs of the holder A14 (Fig. 12) and dispose it with
common municipal waste. Slide the front part of the dust filter (in the direction of the arrow)
to holder in the suction space of the vacuum cleaner and push it to the maximum position.
Close the vacuum cleaner lid by snapping it shut. You will hear a clicking sound.
Replacement dust bags: ETA Original (ETA960068000), ETA Hygienic (ETA960068010),
ETA Antibacterial (ETA960068020), or UNIBAG (ETA990068010).
Note
– The safety feature will not allow the cleaner lid to be closed, if you forget to insert
the dust filter (paper, synthetic or textile).
i
GB
23 / 48
To Next Page
Loading...
