78673B 19-12-11
Clean
Clean 24”
Clean HRB
Washing and cleaning instructions for the product are found on the product
as well as in the product's manual. When cleaning the chassis in a washer,
the product must be secured in an upright position with locked wheels.
The product can be safely cleaned at 85°C for 3 minutes.
Clean the product with a solvent-free cleaning agent with a pH level between
5 and 9, or with 70% rubbing alcohol.
The frequency of inspection/reconditioning depends on how often and how intensively the product is used. Always use Etac's original parts. For more information about the
product, refer to the manual available at www.etac.com.
Remember that the service life of the product is limited (see manual). This is particularly important when instructing users who are expected to use the product for an
extended period of time.
Inspection Deviation Solution
Clean
Clean HRB
Clean 24”
Chassis
The chassis has paint damage
Repair the damage with Etac's touch-up paint.
RAL 9003 (Gloss 90)
The chassis has mechanical damage which
can affect the product's function/safety
Scrap the product
Plastic back
The plastic back is damaged, has cracks,
burrs or sharp edges
Replace the plastic back
The plastic back is not secured Tighten all screws to 3 Nm torque
Screw cannot be tightened Replace plastic back
Soft back
The soft back is damaged, has tears, holes,
broken seams, broken snap locks
Replace the soft back
Reconditioning
Cleaning
Reconditioning/reuse
Etac Clean
Reconditioning instructions
To Next Page
Need help?
General
