§ Do not use flanges or flange nuts with bores larger or smaller than those of the saw blade.
§ Do not try to slow down the rotating saw blade by hand.
§ Fasten the machine down to a stable base before use.
§ The saw head must be able to move freely and return to its upper starting position after it
is released.
§ Do not jam the On/Off switch in position.
§ After the switch is released, the machine must come to a stop within 10 seconds.
§ When doing work that generates dust, wear a breathing mask and protective goggles, do
not smoke and avoid naked flame.
Care! Use the saw blade supplied with the tool for machining wood and wood-
derivative materials only.
Changing sawblade
When removing sawblade, first raise the
lowest position handle, press down the
shaft locking arm to lock the sawblade,
and loosen the hex bolt by turning clock-
wise using the socket wrench. Then
remove the hex bolt outer flange and
sawblade.
Install the new sawblade. Check that the
teeth point in the direction of the arrow
(See protective cover).
3
To Next Page
Loading...