ETC Setup Guide
Congo
™
Radio Remote Focus Unit (cRRFU)
cRRFU Setup Guide Page 3 of 5 Electronic Theatre Controls, Inc.
FCC Notes (914.5MHz US version):
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communication. Operation of this equipment in a residential are is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
In order to maintain compliance with FCC regulation shielded cables must be used with this equipment. Operation
with non-approved equipment or unshielded cables is likely to result in interference to radio and television reception.
EU Notes (433,92MHz EU version):
CE - Product
The RRFU system conforms to the CE requirements set up by the European Community. This can be recognized
by this label on the outside of the product.
R&TTE Regulations (433,92MHz EU version):
The HF modules used are designed and manufactured by Radiometrix (UK) and approved to ETS 300-220-1.
The transmitter is approved according to R&TTE guideline 1999/5/EC and carries the declaration CE0889.
The unit is approved for use in the following countries in Europe:
A, B, DK, FIN, F, D, EL, IRL, I, L, NL, P, E, S, UK, IS, NO, CH
To Next Page
Loading...
