Eternal Lighting EchoMATE

To Next Page

To Previous Page

EchoMATE Eternal Lighting Updated: 03/31/2016

Custom Color A

Custom Color B

Custom Color C

Custom Color D

Custom Color E

Sound

Sound: 1

Sound: 2

Fade

01-10 (Fast to Slow)

Boot time

Work time

Operating Time

Total Operating Time

Battery Capacity

Battery Percentage Indicator

(90-100% is Fully Charged, 20-30% is Low to Depleted Battery)

Note: Will shut off around 20-30% left on Battery Capacity

LCD Display time

Full on

10s/11s/12s…60s

IR INFA

Enable/Disable

Menu:

 Start Up – Welcome to Eternal Lighting Screen - EchoMATE

 Switch to Display- Version - RGBWAU - When RGBWAU is blinking, choose Program RGBWA or

RGBWA+UV, press UP/DOWN and Enter.

 DMX Address and Channel Mode – Press Enter to move up and down between DMX Addr and

CH. Press Down/Up to scroll through choices. Press Enter to save a command then press Menu to

back out.

 Master/Slave – Press Up or Down to change the command of Master or Slave, Enter to save the

command. (NOTE: In order to use the IR Remote Plus, put the EchoMATE in Master Mode. The

EchoMATE will not respond to the IR Remote Plus if it is in Slave Mode)

 Manual – Press Enter to go through Red, Green, Blue, White, Amber, and UV. Press Up or Down to

adjust color brightness on a scale of 0-255. Enter to save. This serves as the Master Dimmer for all

the Pre-set colors.

 SHND –Press Up to scroll through options: Color, Sound, and Fade. Enter to select cho ice.

Eternal Lighting EchoMATE - Menu