ETERNITY G16 - User Operation and Maintenance; User Instructions for Operation

ON
`4 27n
{I
V II
 A
1]
ILTRAI7ER1
v
ON
2ui
A j
..w-
ON/OFF
USER INSTRUCTIONS
PLEASE HAND THIS HANDBOOK TO THE USER AFTER INSTALLATION.
INTRODUCTION:
You have selected the ETERNITY electronic gas hot water unit. The following instructions will
assist you to obtain the best performance from your ETERNITY unit.
OPERATION:
Up to three remote controls are able to be installed with your ETERNITY unit for complete
controls of your hot water.
Please note units without remote control will be set at 60°C or in the case of commercial units 75°C.
OPERATION OF MAIN REMOTE CONTROLS
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS APPLIANCE.
1.
TURN ON THE ON/OFF SWITCH (REFER PG 11 OF THIS MANUAL).
2.
THE TEMPERATURE DISPLAY WILL ILLUMINATE AT 42°C.
3.
THE "T" AND ON INDICATORS WILL ILLUMINATE.
4.
SELECT HOT WATER TEMPERATURE BY PRESSING UP / DOWN BUTTONS ON THE
CONTROLS.
5.
TURN ON A HOT WATER TAP. COMBUSTION INDICATOR WILL ILLUMINATE AFTER
A SHORT DELAY, ON BOTH REMOTE CONTROLS. THESE INDICATORS WILL REMAIN
ILLUMINATED UNTIL THE HOT WATER TAP IS TURNED OFF.
• MAIN CONTROL

• SHOWER/SUB CONTROLS
6.
THE HOT WATER TEMPERATURE CAN BE ALTERED AT ANY TIME DURING THE
OPERATION BY USING THE UP/DOWN BUTTONS LOCATED ON
.
THE CONTROLS.
USER INSTRUCTIONS
15