KL8-3
2
（4）CD frequency input。Display of radio frequency and storage for 10 channels。
（5）Display and 87 grades adjustment of volume。
（6）Long Circulation and Phase of time Circulation cleaning。
（7）Display and set of 24 hours model。
（8）Power loss memory for all setting。
（9）Fahrenheit & Celsiur temperature shift。
（10）Frozen preventing control。
（11）Light of Keys 。
（12） Lock of buttons of computer board。
（13）Selection of 110-120VAC or 220-240VAC，And Single-Phase or Three Phase Four line mode。
（14）Selection one AC power output when “CD” is working，This is using for DVD or TV。
（15）Selection POWER Controll。
（16）Selection electric current of all load are measure。
3. Operations
(1) When first turning on the power，the backlight will bright of halt， and the LCD will show the present time
and temperature。It will show “E1” if the sensor is open/short circuit。When part of radio frequency showed
“---”，it indicates that the status of the system is “Waitting Mode”，so as well as the pre-heat and
circulation cleaning。
Fig﹒3：Normal temperature. Fig﹒ 4：Sensor open circui or short circuit
(2) Lock Operation ：
The lock will start work by pressing “ ”Button in the status of “Waitting Mode”or
no-pressing operation lasting above 30 minute。In the status of Locked， press the button“ ”twice，
the lock will be unlocked。and the word “
LOCKED
”will disappear。
(3) Time setting operation：
In the status of“Waitting Mode” and the pre-heater and circulation cleaning are shut down，
pressing“ ” or “ ” could start time setting。Signal of“：”doesn’t flash but Minute and Hour
flash at this time。It will add 1 hour when pressing “ ” each time，and the hours could be added
continually when pressing the “ ” without stop。The hour adjustment range is 0~23。
In the status of time setting，It will add 1 minute when pressing “ ”each time，and the minutes
To Next Page
Loading...
Need help?
General