EasyManua.ls Logo

ETHINK KL8800A - Working Mode

ETHINK KL8800A
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
KL8800A User Manual
www.ethink
-
spa.com
4
7. The 7th time to click on to set “start automatically replenishing water” , the LCD is
showing “ .
8. The 8th time to click on“ ” to return to set “real clock ” , the LCD is showing “ .
When finish settings(or without pressing any key within 6 seconds), the data will be saved and the
system exit. Any parameter setting or change must be operated within 6 seconds.
***Note***
1. When A1 = ON or A2=ON, press “ ” key, the above step 2 and 3 will be skipped.
2. When A4=ON, the above step 4 and 5 will be skipped.
3. When B3=OFF, then the above step 7 will skipped.
4. When B4=OFF, the above step 6 will be skipped.
5. Only has the operation of “press and hold” and click pressing, the other keys are all
click pressing
6. “Press and hold” means to press the key and hold for a while until it appears some icons or
enters to a certain status.
7. “Click pressing” means to click on the key and let it go within a second.
). Working Mode
1. Three working modes: Normal Mode, Economy Mode and Filter Mode. The working mode is
only effective for circulation pump, heater, circulation filtration and anti-virus function.
2. When A1 = ON, no working mode is available. Press “ ” key to turn on or turn off the
heater, the circulation pump will automatically turn on/off.
3. The switch of working mode:
1) When it is initially powered up, the system is working at the “Filter Mode”, and the LCD is
showing . The system will just work under filter cycle and the heater don’t work under
this mode.
2) The 1st time to press “ ” key, the system enters to “Normal Mode”, and the
LCD is showing “ , the system will keep the setting temperature all day.
3) The 2nd time to press , the system enters to transformation status
from “ Economy Mode” to “Normal Mode”, “ ” is displaying on the LCD and
” is flashing. The system will turn into “Economy Mode” after running
“Normal Mode” for an hour.
4) The 3rd time to press , the system goes into Economy Mode”, the LCD is showing
”. The system will only work during the filter cycle, and it will heat the SPA to your