8
to the probe diameter. Allow the reading from the probe to stabilise
and then compare the reading with either the temperature controller
display or an external reference thermometer. For optimum comparison
accuracy use a high precision ETI Reference Thermometer or similar.
If probes with a large mass are inserted into the dry-well holes the unit
will require up to 10 to 15 minutes to re-stabilise.
MAINTENANCE
CARE OF THE 3000 SERIES UNITS
The 3000 Series of dry-wells require very little maintenance. Avoid
operation in dusty, dirty, oily or wet environments. If the case becomes
dirty it may be cleaned using a damp cloth and mild detergent. Do not
allow moisture to enter the case. It is important to check for and remove
any foreign objects in the dry-well holes.
WARNING: Never introduce any fluids or other foreign material into
the dry-well. This will damage the dry-well and could cause probes to
become lodged. It could also cause a potential electric shock hazard.
In the event that the heat source should require service or repair, please
contact ETI for assistance. There are no user serviceable parts inside
and any attempted repair will void any guarantee.
GUARANTEE
This instrument carries a two-year guarantee against defects in either
components or workmanship. During this period, products that prove to
be defective will, at the discretion of ETI, be either repaired or replaced
without charge. The product guarantee does not cover damage caused
by fair wear and tear, abnormal storage conditions, incorrect use,
accidental misuse, abuse, neglect, misapplication or modification.
Full details of liability are available within ETI's Terms & Conditions
of Sale at www.etiltd.com/terms. In line with our policy of continuous
development, we reserve the right to amend our product specification
without prior notice.
To Next Page
Loading...