ETNA CM751ZT - Setting the Clock

EN 8
When you connect the appliance to the mains electricity for the first time, the DISPLAY
lights up. After threeseconds the clock symbol and ‘12:00’ flash on the DISPLAY.
Setting the clock
Press the settings button
‘increase’ and the selection button
simultaneously. ‘12’ starts flashing.
Use the settings buttons to set thehour.
Press the selection button again. ‘00’
will start flashing.
Use the settings buttons to set
theminutes.
Press the selection button again.
Note
If you press a button, the setting starts to flash. You can now change the setting. You can only
change the setting if it is flashing. If it stops flashing, you must press the button so that the
setting starts flashing again.
1 2
3 4
5
SETTING THE CLOCK