EasyManua.ls Logo

ETNA CMV328ZT/E01 - Before First Use; First Use; Positioning; Using the Microwave

ETNA CMV328ZT/E01
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 9
Before first use
Open the door, remove the packaging and check the microwave fordamage.
Do not use the microwave if it is damaged, contact your supplier.
Remove the protective film from the casing.
Clean the oven interior and accessories with a damp cloth. Do not use any abrasive cleaner
or strong-smelling cleaning products.
First, place the guiding ring and then the turntable in the centre of the oven cavity with the
opening for the drive shaft facing downwards.
Attention!
The microwave may not be used without the guiding ring and turntable.
Positioning
Place the microwave oven on a firm, flat surface.
Make sure that there is sufficient ventilation around the microwave oven. Keep at least a
30cm space free at the top. At the sides, keep at least 20 cm free. The microwave needs to
be at least 85 cm from the floor. The rear surface of appliance shall be placed against a wall.
Do not cover the air vents.
Using the microwave
Microwaves are high-frequency electromagnetic waves. The energy makes it possible to cook or
warm up a dish without affecting the form or colour.
Cooking principle
The microwaves which the microwave generates are spread evenly by a distribution system.
This cooks the dish evenly.
The food absorbs the microwaves to a depth of approximately 2.5cm. Cooking then
continues, because the heat is spread in the dish.
The cooking times vary and depend on the dish you use and the properties of the food:
Quantity and density
Moisture content
Starting temperature (whether or not it is cooled)
FIRST USE

Table of Contents

Related product manuals