ETNA EEK263VA - Installation and Connections

444334
• Place the appliance in dry and well aired room. The appliance
operates best at temperature ranges indicated in the chart be-
low. Relevant class of the appliance is indicated on the rating
plate.
Class Ambient temperature
SN (subnormal) from + 10°C to + 32°C
N (normal) from + 16°C to + 32°C
ST (subtropical) from + 16°C to + 38°C
T (tropical) from + 16°C to + 43°C
Positioning the appliance requires two persons in order to avoid
injuries or damage to the appliance.
• Avoid exposing the appliance to direct sunlight or heat sour-
ces. If this is not feasible, install insulation plate between the
appliance and adjacent heat source.
• The appliance may stand independently or you may incorpo-
rate it into the kitchen cabinet. Be sure to leave enough space
for cooling of condenser (distance from the wall or the opening
should be 200 cm
2
). Distance to the cabinet above the applian-
ce should be at least 5 cm.
After the installation, the appliance mains plug should be
accessible!
• Use the power cord to connect the appliance to the mains
power. Wall outlet must be fi tted with ground terminal (safety
socket). Required nominal voltage and frequency are indicated
on the relevant label or rating plate of the appliance.
• Mains power connection and grounding must be made in line
with standing regulations and local requirements.
The appliance is able to accommodate minor temporary voltage
tolerances, but they may not exceed -6% to +6%.
Selecting the location
Positioning the
appliance
Connecting to power
supply
6
Installation and connections