Installation of Support Feet
In the support feet installation kit supplied in the product package, there are 4 pieces of
support feet, 4 pieces of screw and 4 pieces of washer. Screw the support feet on the product
without the washers as shown in Figure 1. Then place the product on the workbench where it
is to be installed and check whether it stands still or not. Depending on the planarity of the
workbench, in case one of the support feet do not touch on the workbench, use the washers
given in the installation kit as many as required, as shown in Figure 2.
Figure 1 Figure 2
52168492
To Next Page
Need help?
General
