What to do if my ETNA KI680ZT shows an error code?
If you encounter an error code on your ETNA hob, it could be due to a dirty control panel or water on it. Clean the control panel. Alternatively, it could be because you're touching multiple keys simultaneously; avoid operating more than one key at a time.
Why is my ETNA KI680ZT not working and the display is blank?
If your ETNA hob isn't working and the display is blank, it's likely due to a power supply issue caused by a defective cable or faulty connection. Check the fuses or the electric switch if there is no plug.
What to do if a fuse blows when I switch on my ETNA KI680ZT Hob?
If a fuse blows as soon as you switch on the ETNA hob, it indicates that the hob has been wrongly connected. Check the electrical connections.
What to do if my ETNA KI680ZT Hob is not working?
If the ETNA hob is not working and nothing appears on the display, it might be due to a lack of power supply. Check the fuses or the electric switch if there is no plug.
Why does a fuse blow when I switch on my ETNA KI680ZT?
If a fuse blows as soon as you switch on the ETNA hob, it indicates that the hob might have been wrongly connected. Check the electrical connections.
Why did my ETNA KI680ZT Hob cooking zone suddenly stop?
If a cooking zone on your ETNA hob suddenly stops working and you hear a signal, it means the preset time has ended. You can switch off the sound by touching the timer key.
Why do my pans make noise when cooking on my ETNA KI680ZT Hob?
The noise your pans make while cooking on the ETNA hob is due to the energy flowing from the hob to the saucepan. At high settings this is perfectly normal for some pans and will not damage the pans or the hob.
Why does my new ETNA KI680ZT Hob have a smell?
If you notice a slight smell the first few times you use the ETNA hob, it's because the new appliance is heating up. This is normal and will disappear after it has been used a few times. Ventilate the kitchen.
How to clean circle of pan bottom on ETNA KI680ZT?
To address the circle of pan bottom remaining visible after cleaning your ETNA hob, clean the induction hob with a ceramic hob cleaner and remove the dirt / grease from the pan bottom.
Why does the display light up when I first use my ETNA KI680ZT?
The display lighting up when the ETNA hob is activated for the first time is normal operation.
To Next Page
General
