How to deactivate the key lock function on my ETNA KIV164RVS?
If the ETNA hob displays 'Lo' in the timer, it means the key lock function is activated. To deactivate it, switch on the hob, then touch and hold the lock key.
What to do if my ETNA KIV164RVS Hob is not working and nothing appears on the display?
If the ETNA hob is not working and the display is blank, it may be due to a power supply issue caused by a defective cable or a faulty connection. You should check the fuses or the electric switch if there is no plug.
What to do if my ETNA KIV164RVS cooking zone suddenly stops and I hear a signal?
If a cooking zone suddenly stops working on your ETNA hob and you hear a signal, it means the preset time has ended. You can switch off the sound by touching the + key of the timer.
What does error code E5/E6 mean on my ETNA Hob?
Error code E5/E6 on the ETNA hob indicates that the internal temperature is too high, there is an error on the fan left or right, or the air exhaust is blocked (for example, by paper). Check that the fan air exhaust is free. If the error persists, contact an authorised service agent.
What does error code E1/E2 mean on my ETNA KIV164RVS Hob?
If the ETNA hob displays error code E1 or E2, it indicates that the supply voltage or frequency is different from the rated values. To resolve this, switch off the hob and let it cool down until 'H' disappears from the displays. Then, switch the hob back on. If the error persists, contact an authorised service agent.
What does error code E3/E4 mean on my ETNA KIV164RVS?
Error code E3/E4 on the ETNA hob indicates that the internal temperature of the hob is too high. To resolve this, switch off the hob and let it cool down until the 'H' disappears from the displays. Then, switch the hob back on. If the error persists, call an authorised service agent.
Why does a fuse blow as soon as I switch on my ETNA KIV164RVS?
If a fuse blows as soon as the ETNA hob is switched on, it indicates that the hob has been wrongly connected. Have the electrical connection checked.
What to do if my ETNA KIV164RVS Hob displays 'u' and the link function doesn't work?
If the ETNA hob displays ‘u’ and the link function (Bridge cooking zones) doesn’t work, it means the pan you are using is not suitable for induction cooking or has a diameter of less than 12 cm. Use a suitable pan. Bridge cooking zones have to be fully covered by the pans.
Why do my pans make noise while cooking on my ETNA KIV164RVS Hob?
Pans may make noise while cooking on the ETNA hob because of the energy flowing from the hob to the saucepan. This is normal for some pans at high settings and will not damage the pans or the hob.
Why does my new ETNA KIV164RVS have a slight smell when I use it for the first time?
A slight smell from the ETNA hob during the first few uses is normal as the new appliance heats up. This will disappear after it has been used a few times. Ventilate the kitchen.
General| Type | Gas Hob |
|---|---|
| Width | 60 cm |
| Number of cooking zones | 4 |
| Number of burners | 4 |
| Material | Stainless Steel |
| Gas type | Natural Gas |
| Control type | Rotary knob |
To Next Page
