What to do if my ETNA Hob is not working and nothing appears on the display?
If your ETNA Hob isn't working and the display is blank, it indicates a power supply issue. Check the fuses or the electric switch to ensure they are functioning correctly. This could be due to a defective cable or a faulty connection.
What to do if my ETNA Hob shows error code E3 or E4?
Error codes E3 or E4 on your ETNA hob indicate that the internal temperature is too high. Turn off the hob and allow it to cool down until the 'H' disappears from the display. Then, switch it back on. If the error reappears, contact an authorised service agent for assistance.
What to do if my ETNA Hob shows error code E5 or E6?
Error codes E5 or E6 on your ETNA hob indicate that the internal temperature is too high. Ensure the hob has enough ventilation and is correctly installed. Allow the hob to cool down, then try restarting it. Check if the fan is running smoothly; if not, contact a service technician.
Why does my ETNA Hob blow a fuse as soon as it is switched on?
If a fuse blows immediately when you switch on your ETNA hob, it suggests the hob has been wrongly connected. Check the electrical connections to ensure they are properly configured.
What to do if my ETNA KIV264RVS cooking zone suddenly stops working and I hear a signal?
If a cooking zone on your ETNA hob suddenly stops and you hear a signal, it means the preset time has ended. Stop the beeping by touching the + key on the timer.
What does it mean if my ETNA KIV264RVS display shows ‘u’?
If the display of your ETNA hob shows ‘u’ when you switch on a cooking zone, it indicates that the pan you're using isn't suitable for induction cooking or its diameter is less than 12 cm. Use a suitable pan.
Why do my pans make noise while cooking on the ETNA Hob?
If your pans are making noise while cooking on the ETNA hob, it's due to the energy flowing from the hob to the saucepan. This is normal for some pans at high settings and won't damage the pans or the hob.
What to do if my ETNA Hob shows error code E1 or E2?
If your ETNA hob displays error code E1 or E2, it indicates that the supply voltage or frequency differs from the rated values. Contact a certified installer to resolve this issue.
Why is there a slight smell when I use my ETNA KIV264RVS for the first few times?
If you notice a slight smell when using your ETNA hob for the first few times, it is because the new appliance is heating up. This is normal and will disappear after a few uses. Ensure you ventilate the kitchen.
What to do if my ETNA KIV264RVS shows other error codes?
If your ETNA hob displays error codes other than the ones specified, it could indicate a defective generator. In this case, you should contact the service department for assistance.
General| Type | Gas Hob |
|---|---|
| Brand | ETNA |
| Model | KIV264RVS |
| Number of Burners/Cooking Zones | 4 |
| Burner Type | Gas |
| Material | Stainless Steel |
| Depth | 50 cm |
| Ignition Type | Automatic |
| Built-in | Yes |
| Width | 580 mm |
| Control Type | Knobs |
To Next Page
