EN 15
OPERATION
Manual door lock
Available in pyrolytic models only.
This function allows the oven door to be locked. Once the door has been locked, you can start
cooking normally.
This function can only be selected when the oven command functions are set to the
rest position .
1. Touch or until the symbol on the display starts flashing.
▷ The current door lock status will be displayed: “On” if it is activated and “Off” if
deactivated.
2. Touch .
▷ You will hear an audio signal and the lock will be activated if it was “Off”, or deactivated
if it was “On”.
Attention
Before locking, ensure that the oven door is properly closed. If not, it will not lock and
an audio signal will sound. If this happens, switch off the audio signal by pressing any
key, close the door properly and lock again as per the instructions above.
• Once the door has been fully locked/unlocked, the display will show the new door status.
• In the event that the locking system is active, the symbol will appear constantly lit on the
display.
To unlock the door during cooking, turn the function dial to standby and unlock the
door as described above. Once the door is unlocked, turn the function dial back to its
former position to continue cooking.
To Next Page
Loading...
