EasyManua.ls Logo

ETNA VW744HM - Filling the Rinse Aid Reservoir

ETNA VW744HM
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 13
Warning! Proper use of the dishwasher detergent
- Use only detergent specifically made for dishwashers use.
- Keep your dishwasher detergent fresh and dry.
- Fill the detergent dispenser with dishwasher detergent immediately before starting the
wash programme.
- Dishwasher detergent is corrosive! Keep dishwasher detergent out of the reach
of children.
Filling the rinse aid reservoir
1. Open the reservoir cap.
2. Carefully pour in the rinse-aid into its dispenser, whilst avoiding it to overflow.
3. Close the reservoir cap.
Note: Clean up any spilled rinse aid with an absorbent cloth to avoid excessive foaming
during the next wash.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to
adjust the consumption by the user. If the dishes are not drying properly or are spotted, select
a higher setting until your dishes are spot-free. Select a lower setting if there are sticky whitish
stains on your dishes or a bluish film on glassware or knife blades.
1. Switch on the appliance.
2. Within 60 seconds after step 1, touch program key Auto for more than 5 seconds.
3. Touch the Delayed start plus (+) key to enter the setting mode. The rinse aid indicator
blinks.
USING YOUR DISHWASHER

Table of Contents