AMPLIFIER OPERATING
When using dual amplifiers to power one subwoofer, the positive terminal of the
Subwoofer‘s voice coil is connected to the positive terminal of the MASTER amplif ier
and the negative terminal of the Subwoofer‘s voice coil is connected to the positive
terminal of the SLAVE amplif ier. This procedure will allow the total power of both
amplifiers to be added together and act like a single powerful amplifier. Please check
that your subwoofer power handling capabilities are not exceeded when hooking two
amplifiers to it.
Always check your speaker load with a multi-meter before hooking up to the amplifier.
These digital amplifiers are only 1 Ohm stable. any impedance (load) smaller than
1 Ohm will damage the amplifier. This kind of damage is not covered under warranty!
MASTER/SLAVE MODE
10
To Next Page
Loading...
Need help?
General
