ETQ 170F - User Manual

Questions and Answers

E
Elizabeth ShannonAug 4, 2025
What to do if my ETQ Engine stops automatically?
- A
  April CarterAug 4, 2025
  If your ETQ Engine stops automatically, consider these possible causes: a lack of fuel in the system (add fuel to the tank), a clogged fuel line (clean it out), air in the fuel system (clean the system and replace the fuel), an adhered needle valve of the nozzle (clean or grind the nozzle, replacing it if necessary), a clogged air filter (clean it), or a sudden increase in load (decrease the load).
G
gjonesAug 14, 2025
How to fix very black exhaust from my ETQ 170F?
- S
  Stephanie MendezAug 15, 2025
  If your ETQ Engine's exhaust is very black, it could be due to an overloaded engine. Try decreasing the load, or if the driven machine isn't properly fitted, consider changing the engine. Alternatively, there might be a problem with fuel injection; check the injection pressure and spraying conditions, correcting or replacing the nozzle as needed. Insufficient intake air or air leaks could also be the cause; clean the air filter and identify and fix any leaks.
M
mhillAug 19, 2025
Why is the exhaust from my ETQ Engine very blue?
- C
  christinekaiserAug 19, 2025
  A blue exhaust from your ETQ Engine often indicates engine oil is entering the cylinder. Check the oil level and drain any excess. It could also mean the piston rings are worn or their gaps are aligned, allowing oil into the combustion chamber; inspect or replace the piston rings, ensuring the gaps are not aligned. Worn pistons or cylinders, or worn valves or valve guides can also lead to blue exhaust; replace these components as necessary.
B
Bryce NelsonAug 25, 2025
What does white exhaust from my ETQ Engine mean?
- S
  Susan LopezAug 26, 2025
  White exhaust from your ETQ Engine indicates water in the diesel fuel. Clean the fuel tank and diesel filter, and replace the diesel fuel.
V
Victoria ThomasOct 30, 2025
How to start an ETQ 170F Engine that is not starting?
- J
  Joanna RamirezOct 30, 2025
  If your ETQ Engine isn't starting, several factors could be at play. If the weather is cold, the engine oil may be too thick; preheat the oil before putting it into the crankcase and inlet manifold. Disconnect the belts and run the engine under no load until it heats up, then reconnect the belts. Alternatively, the fuel system might be contaminated with water, in which case you should clean the fuel filter and pipe, replacing the old fuel with new fuel. Other potential issues include thickened fuel (use the correct specific fuel), air in the fuel system (drain the air and fuel, then tighten the fuel pipe connectors), or insufficient fuel being injected (check the speed governor handle and clean the fuel injector spray nozzle, and if needed, replace the fuel pump or nozzle). Incomplete comb...
T
Timothy McdonaldNov 8, 2025
Why does my ETQ 170F Engine lack power?
- E
  Erika SparksNov 8, 2025
  If your ETQ Engine lacks power, the issue might stem from several causes. A clogged fuel system, due to a clogged fuel line or filter, could be the culprit; clean the fuel filter and pipe, and ensure the fuel switch is fully open. A bad fuel pump may also be responsible; service or replace any damaged parts. Other potential problems include an incorrectly operating nozzle or incorrect injection pressure (adjust the injection pressure), carbon deposits in the spray hole (clean it out), an adhered needle valve (clean or change it), or a loose fitting between the needle valve and its body (replace either the valve or the body). A dirty air filter (disassemble and clean it) or an engine running too slowly (check the tachometer speed and adjust the high speed limiting screw) could also contribu...