EUFAB 11411 User Manual

5
Not suitable for use with aluminium trailer couplings
D-value at least 7.6 kN
Overview
Introduction
Supporting load Dead weight Payload
50 kg 15 kg 35 kg
60 kg 15 kg Maximum 40 kg
75 kg 15 kg Maximum 40 kg
Introduction Page 5
Intended purpose Page 5
Specications Page 5
Safety notes and important information Page 5
Operating instructions Page 6
Maintenance Page 8
Contact information Page 8
Thank you for choosing the BIKE TWO bicycle rack from Eufab.
GB Rear rack BIKE TWO for trailer coupling, for 2 bicycles with EU operating permit
Item number 11411
WARNING
Intended purpose
Specications
Safety notes and important information
Please read the operating instructions carefully prior to use and observe all safety instructions!
Retain the original packaging, the proof of purchase as well as these instructions for subsequent reference!
Non-compliance can lead to personal injuries, damage to the device or your property!
Please check content of package for integrity and completeness prior to use!
Transportation of two bicycles on the trailer coupling.
Not suitable for use with aluminium trailer couplings
D-value of the trailer coupling must be at least 7.6 kN
Size (L x W x H): approx. 147 x 70 x 44 cm
Weight: 15 kg
Maximum payload: 35 kg (with a permitted supporting load of 50 kg)
40 kg (with a permitted supporting load of 60 kg)
40 kg (with a permitted supporting load of )
• The ball surface of the trailer coupling must be clean, grease-free and free from any paint.
• The bicycle rack will only be seated properly on the coupling when secured and driven for a few kilometres. For this reason, check the xture
again for correct seat and adjust the xture if necessary.
• Check the bicycle rack for damages before use. Damaged or worn parts must be replaced immediately. Only original replacement parts may
be used.
• Modications to the bicycle rack are generally not permitted (mechanical or electrical). This can be very dangerous. Guarantee claims will no
longer be accepted and we can no longer guarantee the correct functioning of the bicycle rack if modications have been made. We are not
liable for any damages caused as a result of incorrect installation, operation or modication.
• Check the lighting of your bicycle rack regularly to ensure correct functioning.
• Make sure that the bicycles are always secured using the frame holder and the wheel tensioning straps. The frame holder should be closed
during transportation.
• Make sure that no parts of the bicycle can be lost (batteries, e-bike battery packs, bicycle pump, tachometer, baskets, saddles etc.). Remove
• these parts before transporting the bicycle!
• Check all tensioning straps and holders of the bicycle rack for secure seating and tighten if required.
• Do not cover the bicycles using tarpaulins, covers or similar.
• The bicycle rack will aect the behaviour of your vehicle. Adapt your driving speed to these circumstances (maximum of 130 km/h). Avoid
sudden steering and control motions.
• When reversing, remember that your vehicle is longer than it would normally be!
• The legal regulations and directives for the transportation of goods on your vehicle apply.
• If your vehicle has a parking assistant, the mounted bicycle rack may result in faulty operation. Deactivate the parking assistant function
when the bicycle rack is mounted.
• If your vehicle is tted with a tailgate that opens automatically, this should be deactivate or only opened manually when the bicycle rack is
• mounted

EUFAB 11411 Specifications

General

Brand	EUFAB
Model	11411
Category	Automobile Accessories
Language	English