Need help?Do you have a question about the Eumig MARK S 802 and is the answer not in the manual?
Adjust projector voltage setting to match mains supply for correct operation.
Remove transport lock wedges before initial connection to mains supply.
Prepare film leader with correct length, trim, and curve for threading.
Feed film into slot while depressing the threading key.
Stop the projector before changing running speed.
Wait for flywheel stabilization after speed change from 24 to 18 fps.
Remove the lamphouse cover to access the lamp.
Ensure neat splices, use quality stripe, avoid antistatic agents for good sound.
General| Lens Mount | Fixed |
|---|---|
| Lamp | 12V 100W |
| Projection Speed | 18, 24 fps |
| Type | Super 8 Sound Projector |
| Film Format | Super 8 |
| Light Source | Tungsten halogen lamp |
| Sound | Magnetic Sound |
| Power Supply | 220-240V AC |
| Lens | F1.3 / 15-30mm Zoom Lens |
To Next Page
