Eureka ATOM SPECIAL EDITION - Page 18

ATOM
SPECIAL EDITION
LIBRETTO ISTRUZIONI
USER HANDBOOK
MANUEL D’INSTRUCTIONS
GEBRAUCHSANWEISUNGEN
INSTRUCCIONES DE MANEJO
18
bility between the plug
and the socket, have
the plug replaced with
a suitable type by the
manufacturer, his af-
ter-sales service, or by
skilled personnel, who
should also check that
the section of the plug
wires is suitable for the
power absorbed by
the appliance.
• Avoid use of multi-
ple-plug adapters
and extension cords.
• The ground wire must
be connected; the
electrical system must
meet the standards
set by local safety
laws and regulations.
• The machine must be
installed only by au-
thorized, qualified per-
sonnel.
• Check that the ma-
chine components
have suffered no
damage during ship-
ping; in the case de-
fects or anomalies are
found, interrupt instal-
lation and request re-
placement.
APPLICATIONS
AND USE
• This grinder dispenser
has been devised for
professional use by
trained personnel.
• The grinder/dispens-
er must be used only
for the application for
which it was designed;
that is, grinding roast-
ed coffee beans. Any
other use must be
considered improper
and therefore dan-
gerous.
• The manufacturer
shall not be held re-
sponsible for damag-
es deriving from im-
proper, erroneous or
unreasonable use of
the machine.
• The appliance must
not be used by chil-
dren or people with
reduced, physical,
sensorial or mental
abilities. It must also
never be used by peo-
ple without the neces-
sary skills and expe-
rience unless under
supervision or during
training. Do not allow
children to play with
this equipment at any
time.
• The machine is not
designed for use in
extreme environmen
-
tal conditions and in
any case at tempera-
tures outside the -5°C
to +30°C range.
• The user must re-
spect the general
safety regulations in
force in the country
in which the machine
is installed as well as
the rules of common
sense, and shall be re-
sponsible for ensuring
that periodic machine
maintenance is cor-
rectly performed.
• The persons installing
and using the ma-
chine and perform-
ing machine mainte-
nance shall inform the
manufacturer of any
defects or damages
due to wear that might
jeopardize the original
safety features of the
machine.
• The installer shall be
responsible for check-
ing that the machine
is installed in tolerable
environmental condi-
tions such as to not to
create health or safety
hazards for those us-
ing the machine.
• Any responsibility de-
riving from compo-
nents manufactured
and installed on the
machine shall be as-
sumed by the respec-
tive manufacturers;
responsibility attrib-
utable to the persons
authorized to use the
machine shall be as-
sumed by the cus-
tomer.
• The device can be
used 24 hours a 24
with intermittent ser-
vice as listed on the
nameplate values Ton
and Toff. The machine
components are de-
signed and built to
ensure at least 1000
hours’ operation.
• Good cleaning and
maintenance also
contribute to deter-
mining long machine
life.