13www.eureka.com
Problem solving
Make sure vacuum cleaner is off and charging plug is unplugged.
N O T I C E : Thermal cut-off
This vacuum cleaner has a special thermostat that protects the vacuum cleaner in case of motor
overheating. If the vacuum suddenly shuts off, proceed as follows: 1) Check the vacuum for
a possible source of overheating such as a full dust cup or clogged filter. If these conditions are
found, fix them and wait at least 30 minutes before attempting to use the vacuum.
2) After the 30 minute period, press the power button. If the vacuum still does not work, call the
Eureka Customer Service HELPLINE at 1-800-282-2886.
Motor will not start
• Make sure cleaner is fully powered.
• See detailed “thermal cut-off” instructions above.
• Make sure cleaner is fully powered.
• Charge battery for 4 hours before using.
Not enough suction
power
Not enough running
time
• Check brushroll for debris. Ensure the vacuum cleaner is switched
off then remove the debris from the rolling brush.
• Or the carpet may be too long.
Brushroll will not turn
or hard to push
• Empty dust cup and clean or change filter. See page 8 for
maintenance instructions.
• Make sure cleaner is fully powered. Charge battery.
• Remove clogs that restrict the airflow.
Direct Current Symbol(Symbol IEC 60417-5031(2009-2))
To Next Page
Loading...
