Eureka Powerspeed NEU202 - Clearing Blockages

10 Eureka Customer Service HELPLINE 1-800-282-2886
How to clear a blockage
If vacuum is not cleaning oors, or
if no suction at end of hose, check
to be sure air path is not blocked.
• Press release button and lift off dust
cup (Fig. 1).
• Empty debris. Hold over wastebasket
and press lever to release bottom lid
(Fig. 2).
• Check lter and lter screen.
Remove any debris and shake off
dust. (See maintenance instructions
on page 9.)
• Loosen end of hose.
• Use a rod or similar blunt implement to
clear a blockage in wand or hose. Flex
hose to loosen debris (Fig. 3). Use
caution if there is any risk that glass
or nails could have become imbedded
in hose.
• Use nger to check for debris in air
path (Fig. 4).
• Reinstall lter and lter screen inside
dust cup and position dust cup onto
vacuum cleaner.
Warning: Never operate vacuum
cleaner without foam lter, lter
screen and dust cup in proper
position.
1
3
2
Make sure vacuum is turned off
and power cord is unplugged.
!
!
CAUTION