Why is the Euroflex vapour M2R Steam Cleaner making my floor too wet?
Your floor may be getting too wet because the front steam jets are being used too frequently. Use them in short bursts only when cleaning tougher dirt or hard-to-reach areas. Another reason could be that the cleaning pad is too wet. Replace the wet pad with a dry, clean one.
What to do if the cleaning pads are getting too soaked when using the Euroflex vapour M2R Steam Cleaner?
If the cleaning pads are getting too soaked, it could be that the boiler is overfilled. Let the steam cleaner run until the excess water ceases. Once the boiler has completely cooled down, remove some water. Another reason might be that the green “Steam Ready Indicator Light” is not illuminated. Wait for the green light to illuminate before use.
What to do if the hard surface floor pad is not adhering to Euroflex Steam Cleaner?
If the hard surface floor pad is not adhering to the steam cleaner, ensure you apply enough pressure when attaching the pad. Position the steam cleaner about 2 inches above the pad and firmly press it down. Alternatively, the floor pad may require replacement due to its age. Replacement floor pads can be purchased at most electrical appliance retail outlets.
Warnings concerning children's interaction with the appliance and safe handling practices.
Precautions related to hot steam release and boiler cap operation to prevent burns.
Guidelines for handling appliances with damaged cords or visible signs of damage.
Emphasizes the necessity of attaching a pad before using the steam cleaner to prevent damage.
Advice on safely handling a hot boiler cap to avoid steam burns during use and opening.
Instructions for attaching the microfiber floor pad and the carpet glider with its pad.
Detailed steps for filling the steam cleaner's boiler with water using the provided bottle.
Advises on using tap or demineralized water and warns against adding detergents or chemicals.
Instructions for refilling the boiler while the steam cleaner is in use, including cooling time.
Crucial warnings about handling the hot boiler cap and potential steam release during refilling.
Comprehensive steps for unplugging, releasing pressure, and refilling the boiler safely.
General| Power | 1500 W |
|---|---|
| Water Tank Capacity | 1.6 L |
| Heating Time | 11 min |
| Steam Pressure | 3.5 bar |
| Weight | 5.4 kg |
| Cord Length | 6 m |
| Type | Steam Cleaner |
| Accessories | brush, measuring cup |
To Next Page
