Why is my Euroflex Vapour M6S Steam Cleaner making the floor too wet?
If your Euroflex Steam Cleaner is making the floor too wet, it might be because you are using the Front Steam Jets too often. Use them in short bursts only when cleaning tougher dirt or hard-to-reach areas. Also, the Cleaning Pad might be too wet. Replace it with a dry, clean pad.
General safety warnings and precautions for using the appliance.
Important notices regarding compliance, usage restrictions, and care.
Warnings about the power cord and general operational cautions.
Guidelines for proper disposal and indications for using the manual.
General description and identification of the steam cleaner.
Technical specifications of the steam cleaner.
Details the key features and benefits of the steam cleaner.
Instructions for attaching and using brush adapters, floor brush, and small brush.
Information about the extension tubes for floor cleaning.
Steps to attach extension tubes and use the window tool.
Instructions for attaching detail nozzle, brushes, scraper, and grout brush.
How to attach microfiber pads and use the shoulder strap.
Warnings and advice for filling the boiler with water.
Steps to turn on the steam cleaner, indicators, and how to release steam.
Instructions and warnings for refilling the boiler while in use.
Steps to turn off the steam cleaner after use.
Instructions for periodic cleaning of the steam cleaner.
Information on replacing accessories and general usage tips.
Instructions for washing and caring for microfiber pads.
Table of common issues, possible causes, and solutions.
Contact details for customer support and service.
General| Model | Vapour M6S |
|---|---|
| Category | Steam Cleaner |
| Power | 1500 W |
| Steam Pressure | 4 bar |
| Cord Length | 5 m |
To Next Page
